Support - ZKTeco Europe Knowledgebase

No USB drive found

Problem: No USB drive found, start boot now..."

When i start the video recorder it just says "No USB drive found, start boot now..." and that all, goes in loop and just restart all the time.

============================ STEP 1 =====================================
* Could you open the NVR and check the hard drive cable?

Its OK.

* Could you check/test to connect our NVR with a HDMI cable to any display/monitor to test if start?


   and when you enter, could you down the resolution to start at any resolution.

 ============================ STEP 2 =====================================

LOAD THE NEW FIRMWARE, ASK FOR THE FIRMWARE FOR YOUR CAMERA MODEL.

Steps:
1. Copy the 2 reovery files in root diretory in USB drive (recommeded to use Kingston or Sandisk)
2. Cut off device power supply
3. Plug the USB drive and power supply
4. The device will detects the USB drive and start to update the firmware
5. After done, check if it is normal

CAMERA:Z8303XE-CL

FILE: Z8303XE-CL.TAR (RESTORE FILES)

 

Attachments:
IMG_3775-1.jpg IMG_3775-1.jpg

Was this article helpful?  yes no
Article ID: 108
Category: Cameras
Date added: 05/11/2020 17:25:25
Views: 9
Rating (Votes): Article not rated yet (0)

Go back